The Speedmaster XL 106-DD works on the principle of the rotary die-cutter, which offers a number of advantages over the flatbed and punch die-cutters which are usually used in the production for in-mold labels. The Speedmaster XL 106-DD is ready for production following 15 minutes of make-ready. No additional adjustments are required due to the precision of the cylinders and the die-cutting form.
For special applications, the Speedmaster XL 106-DD rotary die-cutter is equipped with an innovative magnetic cylinder with extraction. The machine not only cuts out the contour, but also removes even the tiniest injection holes of five millimeters diameter or more completely and reliably. All of this in a single step and at a higher speed than previously possible.
Another plus: For production runs up to 500,000 sheets the cost of tooling is reduced by 50 percent compared to traditional flat bed die-cutting.
Maximal | 15,000 sph |
Min. sheet size | 340 mm x 480 mm (13.38 x 18.89 in) |
Max. sheet size | 750 mm x 1.060 mm (29.52 x 41.73 in) |
Max. cutting format | 740 mm x 1.050 mm (29.13 in x 41.34 in) |
Substrate thickness | 0.03 mm - 0.3 mm (13.39 in x 18.90 in) |
Gripper margin | 10 mm - 12 mm (0.0012 in - 0.012 in) |
*The technical data and maximum production speeds can vary depending on job, substrates and other factors.
Die-cutting cylinder | |
Undercut | 0.7 mm (0.028 in) |
Die-cutting plate | |
Length x width (Cutting plate dependent on cutting contour) | 819 mm x 1.060 mm (32.4 in x 41.73 in) |
Underlay plate | |
Length x width | 760 mm x 1.054 mm (29.92 in x 41.30 in) |
Thickness | 0.20 mm (0.0079 in) |
The Speedmaster 2020 generation uses the immense
spectrum of digital possibilities like no other printing press generation before it.
Now is your opportunity to take advantage of this new potential
and write your success story with us.